BFT VISTA SW SXL Instructions D'utilisation Et D'installation page 29

Diagnostics and warnings
Warnings
Steady Door Open
OP
Flashing Door opening
Steady Door closed
CL
Flashing Door closing
Steady System parameter initialization fail (self-learning) error. Run Autoset procedure again, LP menu
E1
Steady Selection error for automatic door operator type (Dip switch 5) or arm type (Dip switch 1 or arm setting on passive brake board)
E2
Steady Maximum current threshold exceeded error (OVERCURRENT)
E3/E4
Steady Supervised sensor initialization fail error. Run the LS supervised sensor automatic acquisition procedure again
E6
Steady No encoder connection error
E8
Steady no supervised sensor detected.
SO
Steady supervised sensor detected during opening, on Phot Op input.
S1
Flashing failed safety test on sensor during opening.
Steady supervised sensor detected during closing, on Phot Cl input.
S2
Flashing failed safety test on sensor during closing.
Steady supervised sensors detected during opening and closing, on Phot Op and Phot Cl inputs.
S3
Flashing failed safety tests on sensors during opening and closing.
Steady Stop. The door stopped during opening due to a safety device being triggered
ST
Steady Temporary Stand by input act
fr
Fig. AD
INSTALLATION MANUAL
jumper
jumper
Descriptions
Right hinge axis
Left hinge axis
VISTA SW SXL - VISTA SW MXL
AD
- 29