Bartscher 285.620 Mode D'emploi page 41

Substituting the pilot burner nozzle (fig. 14 – pag.5)
To substitute the nozzle of the pilot burner, it is necessary to remove the handles of the container of
the lava stone , unscrewing with a setscrew wrench the socket head screws that fix it (for the models
where it is foreseen).It is necessary to remove the knob and the control panel as in figure 11. After
having cleared the work area, screw the fitting (1) which secures the gas supply pipe of the pilot (2)
to the pilot support (4) and take out the nozzle (3); substitute it with the nozzle suitable for the type
of gas to be used, shown in tables 2-3-4-5-6 (pag.33, 34). Then proceed with assembling the new
nozzle, repositioning the pipe and tightening the fitting fully. Finally, put back the panel and knob.
Gas lavastone grill (fig. 15 – pag.6)
To light the burner of the lavastone grill, proceed in the following way:
- turn the knob (1) from the off position
- push down to the bottom;
- press the button of the piezoelectric lighter (2)
- keep the knob pressed down until the thermocouple heats uo, keeping the pilot lit;
- light the main burner in the desired, going from maximum
To put out the main burner, it is necessary to turn the knob to the right into the position
out also the pilot, turn the knob again, into the off position
Adjustment of the height of the lava stone container
(for the models where it is foreseen; fig.16 – pag.6)
For a better cooking result the machine is equipped with a device that allows the adjustment of the
height of the lava-stone container on three different positions. This device allows to obtain an
optimal distance between the cooking surface and the lava stone granting a better diffusion of the
heat.
It is suggested to use this device as follows:
™ Clasp both levers and draw them softly towards you: in this way the lava stone container is
released from its clamps
™ Turn both levers outside at 45° or horizontally adjusting the height of the container in the
new position.
In order to stop the container in the requested position, push softly the handles on in order to
™
hook it at the clamps
ATTENTION! Only use the appliance under surveillance. While working it is possible that
part of the fat of the foods drops on the underneath lava stone causing sudden flames.
Abnormal functioning
If for any reason, the appliance does not start or stops working during use, check that the energy
supply and the control knobs are set correctly; if all is regular, call customer service.
INSTRUCTIONS FOR USE
into the position
Q
.
Pag. 40/65
;
to light the pilot burner;
to minimum
.
Q
.
, to put