Moser max45 Mode D'emploi page 10

Operating instructions
Important safety information
For your own protection from injuries and electric shocks, the following information must be observed when using
electrical equipment:
Read all the instructions before using the appliance!
· Only use hair clippers to cut human hair.
Only use animal clippers to cut animal hair and animal fur.
· Only connect the appliance to an AC mains power supply. Note the rated voltage.
· Never touch electrical equipment that has fallen into water. Disconnect from the mains immediately.
· Never use electrical equipment in the bath or shower.
· Always position or store electrical equipment where it cannot fall into water (e.g. washbasin). Do not allow electrical
equipment to be exposed to water or other liquids!
· Only use the appliance in dry rooms.
· Always disconnect from the mains immediately after use.
· Disconnect from the mains before cleaning the appliance.
· This appliance is not suitable for use by people (including children) with physical, sensory or mental disabilities or
who do not have the relevant experience or knowledge of using such appliance, unless under the supervision of
or after having received instruction in the use of the appliance by an individual who is responsible for their safety.
Children should be supervised to ensure they do not play with the appliance.
· Only use the appliance for the proper use as described in the operating instructions. Only use accessories recom-
mended by the manufacturer.
· Never use the appliance if the mains cable is damaged. Furthermore, do not use the appliance if it is not working
correctly, if it has been dropped, if it is damaged or if it has fallen into water. In these cases, send the appliance to
our Service Center for inspection and repair. Only specialists properly trained in the handling of electrotechnical
devices may repair electrical equipment.
· Do not hold the appliance by the mains cable to carry it and do not use the cable as a handle.
· Keep the mains cable away from hot surfaces.
· Make sure that the mains cable is not twisted or kinked when stored.
· Never insert or allow any objects to fall into the openings of the appliance.
· Never use the appliance where aerosol (spray) products are being used or where oxygen is released.
· To prevent injury, never use the appliance if the blade set is damaged.
· The appliance is safety insulated and radio screened. It meets the requirements of EU Directive 2004/108/EC
regarding electromagnetic compatibility and EC Low Voltage Directive 2006/95/EC.
Initial Operation
Before starting the appliance, always check the lubricating condition of the blade set.
Oil the blade set, if and when necessary.
Only connect the appliance to the socket while if is switched off.
Should the cutting process be interrupted, always switch off the appliance.
· Connect the mains plug to the socket and switch on the appliance. The appliance has two speed settings.
· After using the appliance, switch it off and disconnect from the mains.
Attaching / removing the attachment combs
Attachment combs can be used to extend the cutting length range.
Accessories are available from your dealer.
Switch off the appliance before attaching / removing the attachment comb.
· Fit the attachment comb onto the bottom edge of the blade set (Fig. I ) and push it over the cutting edge of the
bottom blade until it locks (Fig. I ).
· Push the attachment comb towards the cutting edge of the bottom blade (Fig. II) and remove it from the blade set.
10