Parts Counting Function; Percentage Weighing - Adam Equipment ABW Serie Mode D'emploi

•
Press
display will show "000000" with one digit flashing and the 'LO' LED lit.
•
Use the same method the set the low limits.
•
In order to change the display to "bP inL" or "bP otL" or "bP oFF" to have
beeper sound when the weight is between the limits, outside the limits, or off
please check section
5.3.2

PARTS COUNTING FUNCTION

•
In normal weighing mode, press [FUNC/ → ] and then [Tare/ ↑ ] until the
display shows ''F2 PCS''
•
Press
sample piece values of 10, 20, 50, 100 or 200 pieces. For example, if you
selected PC-20, hand count out 20 pieces and put them on the scale.
•
Press the
entered value. The display will show the number of pieces placed on the pan.
•
If more items are put on the pan, the increased count value will be shown.
•
Press [FUNC/ → ] to exit and go back to the normal weighing mode.

5.3.3 PERCENTAGE WEIGHING

•
In the weighing mode, press [FUNC/ → ] and then [Tare/ ↑ ] until the display
shows "F3 PER".
•
Press the
show "PEr 100".
•
Place the item to be set at 100% on the pan and press the
when the stability indicator comes on.
•
The display will show "%".
•
When another item with a different weight value is put on the pan, the
relative % value would be shown against the initial reference sample
•
Press [FUNC/ → ] key to exit and go back to weighing
© Adam Equipment Company 2020
to accept the value and move to set the low limits. The
[0/ ↵]
6.
and then use the [Tare/ ↑ ] key to go through the preset
[0/ ↵]
key once the stability indicator comes on to confirm the
[0/ ↵]
[0/ ↵] key to set the reference sample value, the display will
[0/ ↵]
value.
mode.
6
key