Multiplex Roxxy BL-Smart Control 940-6 Notice D'utilisation page 12

In this sub-menu the various settings are also available in an end-
less loop indicated by the beeper.
To select a setting, move the throttle stick to the full-throttle position.
You will hear a melody (5-6-5) which indicates that the setting has
been stored.
After the melody the controller emits the next sequence of beeps for
the Parameter menu.
Once you have entered all the settings, leave programming mode
using the "End" function (8 x beep), and switch the controller off.
Explanation of parameter 4: "Cut-off voltage"
To program the appropriate cut-off voltage for the type of battery in the
model, please refer to the following table.
Note:
For NiCd / NiMH batteries the settings are as follows
and High correspond to 25% (min. 4.6 V), 50% and 60% of the initial
battery voltage.
Battery type Low
LiPo 3.0V
NiCd / NiMH 25%
LiFe 2.5V
Optional accessories
A simpler and more convenient method of altering these settings is
to use the low-cost ROXXY
No. 31 8576 (German)
No. 31 8577 (English)
BREMSKRAFT 0%
LiPo
AKKUTYP
ABSCHALTUNG weich
ABSCHALT-SPG niedrig
START-MODUS normal
TIMING-MODUS
BESCHLEUNIG. aus
GOVERNOR aus
Roxxy BL-Smart Control 940-6
Low / Medium
:
Medium
3.1V
50%
2.8V
Smart Control Programming Card.
®
25% 50% 75% 100%
Nixx LiFe - -
- -
hart aus
mittel hoch - -
- -
mittel weich
niedrig mittel hoch
schnell mittel langsam
weich mittel hart
Operating Instructions
6.1 Programming example
The following example explains the method of programming the
"Battery type / LiPo" parameter.
Entering parameter programming mode
1. Disconnect the flight battery from the controller.
2. Switch the transmitter on, and move the throttle stick to the for-
ward
position.
3. Connect the flight battery to the speed controller.
4. After about four seconds the controller confirms programming
mode with a long beep.
5. After a further four seconds you will hear a melody (5-6-5).
Selecting the parameter
1. 1 x beep; leave throttle stick at full-throttle position.
2. 2 x beep; move throttle stick to Stop position.
High
3.2V
60%
2.9V
Selecting the setting
1. The parameters are now available in an endless loop indicated
by the beeper.
2. The controller beeps 1 x (LiPo setting).
3. Move the throttle stick to the full-throttle position.
4. A melody is emitted (5-6-5).
5. The controller reverts to the Parameter menu, and indicates the
next parameter (3 x beep = cut-off mode).
Quitting programming mode
"EXIT" mode should be used to quit programming mode
and save the data.
1. Wait until the controller beeps 8 x.
2. Move the throttle stick to the Stop position.
3. You will hear a confirmation melody (6-5-6).
4. finished
4
# 31 8573