GYS NOMAD POWER 10 Mode D'emploi page 9

Translation of the original instructions
• If your eyes or skin come into contact with battery acid, rinse the
affected part of the body with plenty of water and seek immediate
medical assistance.
Connection / disconnection:
• Disconnect the power supply before connecting/disconnecting
the device to/from the battery
• The terminal of the battery that is not connected to the car frame
must be connected first. The other connection must be made on
the car frame, far from the battery and the fuel line. The battery
charger must be connected to the power supply network.
• After the starting, disconnect the booster from the power supply
network and remove the connector from the car frame and then
the connector from the battery, in this order.
Class II device (NOMAD POWER 10 charger).
Class III device (NOMAD POWER 10).
Maintenance:
• The power supply cable cannot be replaced. If the cable is
damaged,the device should not be used.
• Service should be performed by a qualified person
• Warning! Always remove the power plug from the wall socket
before carrying out any work on the device.
• Under no circumstances should solvents or other aggressive
cleaning agents be used.
• Clean the device's surfaces with a soft, dry cloth.
Regulations :
• The device complies with European Directive.
• The certificate of compliance is available on our website.
•EAC conformity mark (Eurasian Economic Commission)
Disposal:
• This product should be disposed of at an appropriate recycling
facility. Do not dispose of in domestic waste.
• The battery fitted in this device is recyclable. Please proceed
according to the applicable recycling regulations.
• The battery must be removed from the device before the latter is
discarded.
• The device must absolutely be disconnected from the power supply
network before removing the battery.
NOMAD POWER 10 EN
9