GYS NOMAD POWER 10 Mode D'emploi page 12

Translation of the original instructions
FLASHLIGHT FUNCTION
PROTECTIONS
This device is protected against short-circuits, overloads, deeply discharge and polarity inversions.
TROUBLESHOOTING, CAUSES, REMEDIES
TROUBLESHOOTING
No response while pressing the ON/
1
OFF button
«Error» light ON on the jumper
2
«Error» light flashes red + alarm
3
The device is warm whilst connec-
4
ted to a laptop.
WARRANTY
The warranty covers faulty workmanship for 2 years from the date of purchase (parts and labour).
The warranty does not cover:
• Transit damage.
• Normal wear of parts (eg. : cables, clamps, etc..).
• Damages due to misuse (power supply error, dropping of equipment, disassembling).
• Environment related failures (pollution, rust, dust).
In case of failure, return the unit to your distributor together with:
- The proof of purchase (receipt etc ...)
- A description of the fault reported
12
NOMAD POWER 10
Press the ON/OFF button
Briefly press the button
mal, flash, SOS and OFF).
The NOMAD POWER is discharged.
Internal battery voltage < 11.0V.
cable.
Polarity reversal
Short-circuit
beep.
Clamps have been left connected to
the battery.
for 3 seconds to turn on the LEDs.
to switch lighting modes (4 available modes: nor-
CAUSES
-
REMEDIES
Charge the product (see page 8).
Charge the product.
Check that the clamps are well
connected and unplug/plug back
the jumper cable.
Check that the clamps are well
connected and unplug/plug back
the jumper cable.
Remove the 2 clamps from the
car battery in order to protect the
device.
Remove laptop's battery or unplug
the NOMAD POWER from the laptop
for 5 minutes and plug it back
again.
EN