GYS NOMAD POWER 10 Mode D'emploi page 10

Translation of the original instructions
OPERATION
Indicators
Lights
Internal battery
capacity for the
device
Indicators flash in turn, whilst charging the device. The number of indicators ON indicates the capacity of the NOMAD
POWER internal battery. All lights are steady if the battery is on hold or the charge is complete.
!
RECHARGE THE NOMAD POWER before first use and after each use.
INTERNAL BATTERY CHARGING
OR
OR
not supplied
STARTING THE VEHICLE
Emergency start function for petrol or diesel vehicles with a 12V battery.
To start a vehicle, please process as follows:
!
If the NOMAD POWER voltage is inferior to the vehicle voltage, the NOMAD POWER will not operate.
1
SMART
BOOSTER CABLE
Error
2
Start
10
NOMAD POWER 10
Press the ON/OFF button
1 flashing 1 steady
0% 25%
1 - Connect mains adaptor to domestic mains.
2 - Connect the other end to the NOMAD POWER
1 - Connect car adaptor to the car cigarette lighter socket.
2 - Connect the other end to the NOMAD POWER
1 - Plug the USB cable to a charger with a USB output (not supplied)
2 - Plug the other end to the NOMAD POWER
Connect the jumper cable to the NOMAD POWER connector.
If the lights «Start» and «Error» flash alternately in green and red, the product is ready.
If the red light only is ON, the internal battery voltage of the NOMAD POWER is too low.
In this event, charge your device.
to check internal battery level of the NOMAD POWER.
2 steady
50%
3 steady 4 steady
75% 100%
to start the charge.
to start the charge.
to start the charge.
EN