Installation and Maintenance Instructions
• The motor is equipped with sealed bearings and requires no
maintenance.
• The threaded dome ring joint should be well lubricated
with petroleum or a soap-thickened mineral oil. If corrosive
products have accumulated on joints and cannot readily be
removed with solvents, the parts should be discarded and
replaced.
Cleaning the Dome
NOTE: Maintenance procedures sometimes require fixtures to be
hosed down for good housekeeping. The electrical circuit should
be turned off prior to hosing down the light.
Clean the dome periodically to maintain maximum light output.
Use only mild, non-abrasive cleaning agents.
Getting Repair Service or Technical Assistance
Products returned for repair require a Return Authorization form.
To obtain repair service or technical assistance for the product, call
Federal Signal at 708-534-4756 or 877-289-3246. For instruction
manuals and information on related products, visit:
http://www.federalsignal-indust.com
Ordering Accessories and Replacement Parts
Typical spare parts are listed in Table 4. To order accessories and
replacement parts, please call Federal Signal Customer Support at
708-534-4756 or 877-289-3246.
Description
Wall Mount Bracket
Corner-Mount Bracket
Mounting Bracket, Surface
Kit, Shock Mount
Conduit Hub Kit, 3/4" NPT
Close-Up Plug, 1"NPT
16
Table 3 Accessories
Models 371-120 and 371L-120
Part Number
LWMB2
LCMB2
371BRCKT
K8459A076
K8459138
K8459130