Wiring The Light; Figure 2 Adjusting The Light Beam - Federal Signal Commander 371-120 Manuel D'installation Et D'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installation and Maintenance Instructions
DOME ASSEMBLY
DIE CAST RING
PIVOT SCREWS (2)

Wiring the Light

SHOCK HAZARD—To avoid electrical shock hazards, do not
connect wires while power is applied.
The Model 371/371L comes assembled from the factory with
two color-coded leads for wiring to a junction box. If desired, the
factory leads can be removed and the supply connections can be
directly made to the terminal block located on the backside of the
motor mounting base as described below.
10

Figure 2 Adjusting the light beam

Models 371-120 and 371L-120
TURN DIE-CAST RING
COUNTER-CLOCKWISE
TO REMOVE
LOCKING SCREW
ADJUST LAMP TO
DESIRED POSITION
290A7365

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Commander 371l-120

Table des Matières