Using The; Receiver Card Functions; Using The Display To Activate Functions Self-Test - AERMEC GLF10M Manuel D'utilisation

USING THE

DIP SWITCH SETTINGS SYSTEM
The board has specific configuration dip-switches for the possible installations.
Dip_Board Position
On
Dip 1
Off
On
Dip 2
Off
On
Dip 3
Off
On
Dip 4
Off
On
Dip 5
Off
On
Dip 6
Off
On
Dip 7
Off
On
Dip 8
Off

RECEIVER CARD FUNCTIONS

The thermostat for GLF grids can be paired with a display that can handle the following functions:
• Infra-red interface for the VMF-IR remote control
• LED interface displaying fan coil status (mode, alarms, inverter fan max speed, etc.)
• On-switch for specific functions, including: selecting procedure for changing the inverter fan max speed, beginning self-test procedure.
Although its electronic system has been totally redesigned, the display layout will be identical to the current display on our fan coil
cassettes, which is shown below:
USING THE DISPLAY TO ACTIVATE FUNCTIONS
SELF-TEST
To activate the self-test function, you must first press the AUX button to power up the system and then supply voltage to the device by
holding down the AUX button. After about 5 seconds, following a sound alert, the self-test procedure will begin. Each press of the AUX
button activates a different function:
Upon terminating the self-test procedure you must stop and restart the power supply to the regulator.
Management of electric heater in replacement mode (2t + 2f)
Management of the electric heater in integrative mode
Blue LED
Red LED
Press
1^
2^
3^
4^
5^
6^
7^
8^
Meaning
Shut-off valve fitted
No shut-off valve
Water probe upstream of the valve
Water probe downstream of the valve
Continuous ventilation
Thermostat-controlled ventilation
Reduced band enabling
Normal band enabling
4-pipe fan coil
2-pipe fan coil
Supplementary heater present
Supplementary heater not present
Dead band 2°C
Dead band 5°C
Function activated
V1 activated
V2 activated
V3 activated
V4 activated
Y1 valve output
Y2 valve output
ELECTRIC HEATER and V2 activated
Ends self-test procedure
AGLF10NFJ 2006_5905145_04
AUX
White LED
Green LED
25