Publicité
Les langues disponibles
Les langues disponibles
6.
Draw end of bunch with brown, black/green and grey/green leads to right standing lights:
a) Disconnect 6-input side joint from standing lights and connect with suitable joint in electric bunch. Connect
remaining joint of electric bunch to standing lights.
Draw remaining end of bunch with 6-input joints to left standing lights:
7.
a) Disconnect 6-input side joint from standing lights and connect with suitable joint in electric bunch. Connect
remaining joint of electric bunch to standing lights.
8.
Place 6-input joint behind left side casing in boot.
Connect additional control set in vehicles with light installation control using 6-input connection built in bunch.
This connection is not used in vehicles without light installation and bridge connection shall not be disconnected.
Additional set for electric installation control
9.
There is a bunch of leads at the left side of vehicle, running towards lid in boot. Find grey/white lead(fog lights
function) in this bunch, cut it in a suitable place and insulate both ends at ca. 5 mm length:
a) Fasten enclosed cap at the end of lead running forwards and put on cap casing,
b) Fasten enclosed cap at the end of lead running towards standing lights and put on cap casing,
c) Connect both assembled casings to suitable casings in electric bunch (grey and grey/white leads).
10.
Vehicles without reversing control system (APS) and with 8-conduit system APS (at the front and at the rear):
Leave white/green lead not connected in boot. Cut the end off and insulate the
lead. The lead cannot contact vehicle ground. In vehicles with 8-conduit reversing control system, driver can be
manually switched off with suitable switch (see vehicle instruction).
11.
Vehicles with reversing control system (APS):
Draw white/green lead to reversing control driver located under door post. Dismantle 16-input plug from reversing
control driver and remove secondary protection. Take plug slag from casing. Disassemble end from container no. 5
(in most types, it is a red/white lead) and assemble white/green lead with end in this place. Leave red/white lead
unconnected beside the driver. Reassemble casing and reconnect it to reversing control driver.
12.
Trailer power supply:
Refer to 13-pin version. 3-pin connector housing (red/blue, yellow, white/brown, white/brown cables) is provided
for expanded socket functions. Put this part of cable set behind the trim. To expand socket functions it is necessary
to order the following parts:
Function "current supply and earth"
Function "current supply, charge line and earth" part no. 015-069
Secure the cable set with supplied cable ties, re-install all trims and other parts which were removed during
installation.
Connect the earth lead to the battery and check all vehicle functions with connected trailer or suitable testing
device.
article no. 014-199
part no. 014-169
Publicité
