6
2 General Safety Precautions
2.1 Definition of symbols and instructions
WARNING !
E
CAUTION !
2.2 Obligation of the operator before start-up
In accordance with the EC Machinery Directive, the measuring system is considered to
be a machine part for fitting into a system/machine. Moreover, the conformity of the
measuring system was investigated in respect of the EMC Directive.
It is therefore only permitted to start up the measuring system if it has been established
that the system/machine into which the measuring system is to be fitted satisfies the
provisions of the EC Machinery Directive, the EC EMC Directive, the harmonized
standards, European standards or the corresponding national standards.
2.3 General risks when using the product
The product, hereinafter referred to as "the measuring system", is manufactured
according to state-of-the-art technology and accepted safety rules. Nevertheless,
improper use can pose a danger to life and limb of the user or third parties, or
lead to impairment of the measuring system or other property!
Only use the measuring system in a technically acceptable state, and only for its
designated use, taking safety and hazard aspects into consideration, and paying
attention to the user manual! Especially faults which could threaten safety should be
eliminated without delay!
Edition: 2017-05-31
All manuals and user guides at all-guides.com
means that death, serious injury or major damage to property could occur
if the stated precautions are not met.
means that minor injuries or damage to property can occur if the stated
precautions are not met.
indicates important information or features and application suggestions
for the product used
means that appropriate ESD-protective measures must be considered
according to DIN EN 100 015-1.
(Cause of a potential equalization between body and device-mass as well
as the housing-mass about a high-impedance resistance (approx.
1 MOhm) e.g. with a commercial ESD wrist strap).
HYDAC ELECTRONIC GMBH
HNT 122x-x-xxxx-000
Part No.: 669940