SOUNDMASTER PL550BR Mode D'emploi page 11

NOTE:
- Remove the stylus protector.
- Be sure that the tone arm is being detached from the tone arm rest before operating and
re-secured again after wards.
1. Select to "Phono" function from Function knob (7)
2. Set the speed selector (22) to the proper position depending on the record to be played.
3. Place the record on the platter (use the Spindle Adaptor (21) if required).
4. Lift the tone arm from the rest and slowly move it to the record side. The platter will
start to rotate.
5. Place the tone arm to the desired position of the record.
6. Adjust the volume (16) to the desired level.
7. At the end of the record, the platter will automatically stop rotating. Lift the tone arm
from the record and return to the rest.
8. To stop manually, lift the tone arm from the record and return it to the rest.
As some kind of record the auto-stop area was out of the unit setting, so it will stop before the last track
REMARK :
finish. In this case, select the Auto-Stop Switch (23) to "Off" position. Then it will run to the end of the record but will
not stop automatically.(Turn off the unit by power button or switch back the Auto-Stop Switch(23) to "On" position to
stop the platter rotate). Then put back the tone arm to the rest position.
Due to Aux and Phono were designed at the same position of this system. When Aux in jack (18)
REMARK :
plugged by 3.5mm plug. The channel will change to Aux automatically and turntable will stop to rotate. Please
ensure the Aux in jack (18) without plugged by anything before playing Phono.
Connect the unit to other device by connecting the Aux in jack (18) with a 3.5mm cable(not provided) and other end
connect to the external device such as Discman/MP3 player to perform the music playback or encoding function
etc.
1. Slide the Function knob (7) to Phono/Aux position.
2. Adjust the Power ON-OFF/ Volume Control Knob (16) to desired volume level.
3. Start to play your external device.
Connecting / Removing of USB
To connect or remove the USB turn off the power or switch the function mode to either Phono or Tuner first.
The system is able to decode and playback all MP3 file which stored in the memory media with USB connecting
port.
1. Plug-in the USB with the face up and make sure it going into completely.
2. Connecting the USB upside down or backwards could damage the audio system. Check to be sure the
direction is correct before connecting.
3. Switch the unit on and turn the Function knob (7) to USB mode
4. The system will start reading and playback the file in the storage media automatically after connecting and
the Play LED indicator (14) will light up.
Remark : USB port does not support connection with USB extension cable and is not designed for communicate
with computer directly.
Play / Pause / Stop mode
1. To interrupt, press the "Play/Pause/Stop button (13) once, the Play LED indicator (14) will be flashing.
Press again to resume normal playback.
2. If press and hold the "Play/Pause/Stop button (13) for two seconds during playback mode. The system will
go to stop mode.
To start playback again, press the "Play/Pause/Stop" button (13) to start playback, the first track will start
3.
playback and the Play LED indicator (14) will light
3
PHONO OPERATION
AUX-IN OPERATION
USB OPERATION
up.
PL550BR / English Instruction Manual