T
HREADING THE
THREADING THE NEEDLE
P
T
REPARING TO
HREAD
to raise the presser foot lifter before you proceed to thread
the machine.
2. Raise the needle in highest position by turning the
handwheel toward you.
NOTE:
It is very important to raise the presser foot lifter before you
thread the machine. Not doing so will likely result in poor
the fabric. Always raise the presser foot lifter before you begin
threading the machine.
S
S
T
ETTING
POOL OF
HREAD ON
1. Pull up the left end of spool pin and set the felt washer and
the spool of thread on spool pin so that the thread unrolls
from the front of the spool.
2.
a. Reverse spool cap direction according to the size of
spool.
b. Use the small spool cap when you use cross wound
thread. Leave small opening between cap and spool as
illustrated.
c.
easily.
M
ACHINE
M
ACHINE
S
P
POOL
IN
T
U
HREADING THE
PPER
1. Hold thread in both hands and pass thread into the guide
from front opening.
2. Bring thread backward and pass through the slit from right
to left.
3. Bring thread to the left and pull thread down toward you
along the slit.
4. Pull the thread around the U-turn, then bring it back up.
5. To thread the take-up lever, draw thread up and bring
thread back down again from right to left along the slit.
6. Pull thread downward along the slit.
7. Draw thread through thread guide from right side opening.
8. Pass through needle eye from front to back.
Refer to next page for instructions on how to use needle
threader.
19
T
HREAD