Embroidery Preparation - Singer SE300 Manuel D'instructions

by attaching the embroidery unit as follows.
CONNECTING THE EMBROIDERY UNIT
will open automatically when connecting the embroidery unit.
1. Turn the machine off before connecting the embroidery unit.
3. If needed, use the level adjusting feet so that the machine
and embroidery unit are even with one another.
T R E
O EMOVE THE MBROIDERY
1. To store the embroidery unit into the box, move the carriage
to park position by selecting Park Position in the Hoop
2. Turn off the machine.
and slide the unit to the left to remove it.
The cover of the socket closes automatically.
U
NIT
42
E
MBROIDERY
ATTACHING THE EMBROIDERY FOOT
1. Remove the presser foot and holder.
a
hand wheel toward you.
4. Tighten the presser foot screw securely.
MESSAGES AT START UP
When you turn the machine on, a series of messages will
appear on the screen.
a. If the needle is not in its highest position, this message
will appear. Turn the hand wheel toward you to raise the
c. If presser foot is lowered, this message will appear. Raise
When the messages a-c have cleared the screen, the
carriage will move to start point.
P
REPARATION
b
c
✓
✓
✓