Thread Cutter; Top Cover; Hand Wheel - Singer SE300 Manuel D'instructions

T C (I)
HREAD UTTER
Use this cutter if the Thread Cutter button is not used.
1. Raise the presser foot and bring fabric and threads
backward after sewing.
2. Hook the threads to the thread cutter from back to front.
3. Pull the thread tails to cut the threads.
P R
RESSURE EGULATOR
The correct presser foot pressure allows fabrics to feed
properly while sewing. The setting of the presser foot pressure
is determined mainly by the weight of the fabric being sewn.
canvas, the pressure in increased.
To increase the pressure, turn dial to 5.
To decrease the pressure, turn dial to 1.
T C (K)
OP OVER
To open the top cover, lift up the front right side of the cover.
H W (L)
AND HEEL
should always turn hand wheel toward you.
(J)
S U
ETTING
D F L
ROP EED EVER
The feed dogs project up through the needle plate, directly
below the presser foot. Their function is to move the fabric
back of the free arm controls the feed dogs.
should be in this position.
be moved by hand, move the lever to the left to lower the feed
dogs.
NOTE:
After sewing with the feed dogs lowered, push the Drop
dogs engaged. Push the lever to the right and then turn the
handwheel toward you one full revolution. This will re-engage
the feed dogs.
M
M M
OUNTING ACHINE IN
There are two holes on the underside of the machine designed
for mounting the machine into a sewing cabinet. Align the
12
M
P THE ACHINE
(M)
S C
EWING ABINET
N
(N)