What To Do If - Electrolux EB4GL70CN Notice D'utilisation

2. Remove the metal ring and clean the
glass cover.
3. Replace the lamp with a halogen, 230
V, 40 W, 300 °C heat resistant oven
lamp.
4.
Attach the metal ring to the glass cov-
er.

12. WHAT TO DO IF...

WARNING!
Refer to the Safety chapters.
Problem
The appliance does
not heat up.
The appliance does
not heat up.
The appliance does
not heat up.
The appliance does
not heat up.
The appliance does
not heat up.
The lamp does not
operate.
"Demo" comes on in
the display and the
appliance does not
heat up.
The fan does not
operate.
Possible cause
The appliance is deactiva-
ted.
The clock is not set.
The necessary settings are
not set.
The Child Lock is activated.
The fuse is released.
The lamp is defective.
The test mode is activated.
5. Install the glass cover.
Replacing the side lamp:
1.
Remove the left shelf support.
2. Use a Torx 20 screwdriver to remove
the cover.
3. Remove and clean the metal frame
and the seal.
4. Replace the lamp with a halogen, 230
V, 25 W, 300 °C heat resistant oven
lamp.
5. Install the metal frame and the seal.
Tighten the screws.
6.
Install the left shelf support.
Activate the appliance.
Set the clock.
Make sure that the settings
are correct.
Refer to "Activating and de-
activating the Child Lock
function".
Make sure that the fuse is
the cause of the malfunc-
tion. If the fuse releases
again and again, contact an
authorized electrician.
Replace the lamp.
1. Deactivate the appli-
ance.
2.
Touch and hold
the appliance activates
and deactivates.
3.
Touch and hold
at the same time un-
til an acoustic signal
sounds and "Demo"
goes out.
ENGLISH 17
Remedy
until
and