Power Fist 8843799 Mode D'emploi page 8

8843799
IDENTIFICATION KEY
A Punch die
B Punch
C Oil plug
D Air punch/flange tool
E Clamp
F Anvil
G Plate guard
H Trigger
I Air inlet
ASSEMBLY & INSTALLATION
Letter references in parenthesis (A) refer to the included Identification Key.
INSTALL AIR COUPLER PLUG
Prepare a standard 1/4 in. NPT coupler plug (sold separately) for use with
your tool.
1. Wrap the external threads of the coupler plug with sealant tape.
a. Wrap tape in a clockwise direction so it will not unravel.
b. Do not tape all the threads. Leave several leading threads
unwrapped for easier alignment.
2. Screw the coupler plug into the tool's air inlet and tighten with a
wrench until snug.
3. Run the compressor at a low volume and check the connection for air
leaks. Do not use the tool until all air leaks are repaired or the faulty
component is replaced.
4. Set the working pressure at 90 PSI / 6.3 BAR.
IMPORTANT! Vibration may cause failure if a quick coupler is connected directly
to the air tool. To overcome this, connect a leader hose to the tool. A quick
coupler may then be used to connect the leader hose to the air line hose.
TOOL HEAD ROTATION
The tool head can rotate 360 degrees. Twist the tool head up to 180 degrees
in either direction to match the workpiece's angle.
8
5/16 in. Pistol Grip Air Punch and Flange Tool
For technical questions call 1-800-665-8685
V1.0