WARNING: To reduce the risk of electric shock, wiring should be performed by a qualified electrician! Incorrect assembly
can cause electric shock or damage the motor and the controller! Hazard of electrical shock!
WARNING: The installation of a Big Ass Fan must be in accordance with the requirements specified in this installation
manual and with any additional requirements set forth by the National Electric Code (NEC), ANSI/NFPA 70-2011, and
all local codes. Code compliance is ultimately YOUR responsibility! Failure to comply with these codes could result in
personal injury or property damage.
WARNING: Exercise caution and common sense when powering the fan. Do not connect the fan to a damaged or
hazardous power source. Do not attempt to resolve electrical malfunctions or failures on your own. Contact Big Ass Fans
if you have any questions regarding the electrical installation of this fan.
CAUTION: The fan must operate on a dedicated circuit with a dedicated neutral. Failure to install the fan on a dedicated
circuit can cause the fan to operate improperly.
CAUTION: Do NOT install the fan where it may come into direct contact with water unless the fan is labeled, "Suitable for
use in wet locations."
Power requirements
110–125 VAC Isis (indoor)
Fan diameter
8 ft (2.44 m)
10 ft (3.04 m)
12 ft (3.70 m)
110–125 VAC Isis (outdoor)
Fan diameter
8 ft (2.44 m)
10 ft (3.04 m)
Wire color chart
North America
100–120 V system
North America
208–240 V system
Australia
All other regions
Electrical Installation
Input power
110–125 VAC, 60 Hz
110–125 VAC, 60 Hz
110–125 VAC, 60 Hz
Input power
110–125 VAC, 60 Hz
110–125 VAC, 60 Hz
AC Line (L1)
AC Line/Neutral (L2/N)
Black
Black, Red, or Blue
Brown or Red
Brown
WWW.BIGASSFANS.COM
Isis
®
Minimum required
supply circuit size
10 A
10 A
10 A
Minimum required
supply circuit size
10 A
10 A
White
Red, Blue, or Black
Black or Light Blue
Green with Yellow Tracer
Blue
©2014 DELTA T LLC
ALL RIGHTS RESERVED
Full load
amps
3.9
3.9
3.9
Full load
amps
1.4
1.2
Earth/PE
Green or Bare Copper
27