2C. Secure Safety Cable (To Solid Beam); 2D. Secure Safety Cable (To Solid Beam With Safety Clips); Attach Main Fan Unit (To Extension Tube) - BIG ASS FANS Isis Guide D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

2c. Secure safety cable (to solid beam)

WARNING: The safety cable is a crucial part of the fan and must be installed
correctly. If you have any questions, call Customer Service.
Secure the safety cable to the mounting structure by wrapping it around the structure
and securing the loose end with the Gripple
tightly around the structure, leaving as little slack as possible with the Gripple tucked
inside the extension tube.
Note: Exact installation may differ from the illustration.

2d. Secure safety cable (to solid beam with safety clips)

WARNING: The safety cable is a crucial part of the fan and must be installed
correctly. If you have any questions, call Customer Service.
Safety clips are used only when the top of the mounting structure is inaccessible due to a
ceiling.
Route the safety cable through the (2) carabiners on the safety clips, leaving as little
slack as possible. Secure the loose end with the Gripple as shown.
Note: Exact installation may differ from the illustration.

3. Attach main fan unit (to extension tube)

Before attaching the main fan unit to the extension tube, route the
power cable from motor through the extension tube and upper mount.
CAUTION: The main fan unit is heavy. Use caution when raising it.
CAUTION: Do not discard the main fan unit packaging and foam. It
should be used if the fan is ever moved or relocated.
Raise the main fan unit directly from its packaging to the extension tube.
Attach the lower mount to the extension tube using the Main Fan Unit
Hardware as shown.
Tighten the hardware to 10 ft·lb (13.6 N·m) using an 8 mm Allen wrench
and a torque wrench with a 17 mm socket.
If the hardware is stainless steel (outdoor fans only), do not use
power tools!
Main Fan Unit Hardware (BAF-Supplied):
a. (1) M10 x 90 mm Socket Head Cap Screw
b. (2) M10 Flat Washer
c. (1) M10 Nylock Nut
d. (1) 3/8" x 3/4" OD x 1/2" Spacer
Hanging the Fan (cont.)
as shown. The cable must be drawn
®
WWW.BIGASSFANS.COM
©2014 DELTA T LLC
Isis
®
ALL RIGHTS RESERVED
Ceiling
Safety Clip
& Carabiner
b
d
b
a
21
c
Power Cable
Lower
Mount

Publicité

Chapitres

Table des Matières
loading

Table des Matières