Attach Guy Wire Clamps - BIG ASS FANS Isis Guide D'installation

22
Guy wires may not be included in your fan order. They are intended to restrain the fan's lateral movement and are only
included in fan orders that have extension tubes 4 ft (1.2 m) or longer. Depending on the operational environment (wind,
mounting structure, etc.), guy wires may be needed regardless of extension tube length. If, during operation, any lateral
movement (wobbling) occurs, a guy wire kit should be purchased from Customer Service.
WARNING: Disconnect power to the fan before installing the guy wires.

1. Attach guy wire clamps

Position the guy wire clamps on the extension tube as close to the motor as possible. Refer to the diagram below. Secure the clamps
to the extension tube using the Guy Wire Hardware.
Guy Wire Hardware (BAF-Supplied):
a. (2) 1/4-20 x 1" Carriage Bolt
b. (2) 1/4-20 Nylock Flange Nut
Installing Guy Wires
WWW.BIGASSFANS.COM ©2014 DELTA T LLC
Isis
®
ALL RIGHTS RESERVED
Guy Wire Clamps
a
b