Scan Sensitivity Setting - Fm - PERFECTPRO DAB+BOX2 Mode D'emploi

Scan sensitivity setting – FM
Your radio will normally scan for FM broadcasts which are strong enough to give good reception.
However, you may wish the Auto-scan function to also be able to find weaker signals, possibly
from more distant radio transmitters. Your radio includes "Strong stations only" and "All Stations"
options for the Auto-scan function.
1. Press the Power On/Off button to switch on your radio.
2. If needed, press and release the Source button until the FM band is selected.
3. Press and hold the Info/Menu button to access FM menu. Rotate the Tuning control knob until
"Scan setting" shows on the display. Press and release the Tuning control knob to enter the
scan sensitivity adjustment mode. The current setting will be marked with an asterisk.
4. Rotate the Tuning control knob to switch between "Strong stations only" and "All Stations" op-
tions on the lower line of the display. The "All Stations" option will allow the radio to find weaker
signals when scanning.
5. Press and release the Tuning control knob to confirm your selection. The setting is stored in
the radio and remains in force until changed or until a System Reset.
Preset stations in DAB and FM mode
There are 5 memory presets for each DAB/FM wavebands.
1. Press the Power On/Off button to switch on your radio.
2. Tune to the required station as previously described.
3. Press and hold the required Preset button until the display shows e.g. Preset 2 stored. The
station will be stored under the chosen preset button. The corresponding preset number
e.g."P2" will show on the display. Repeat this procedure for the remaining presets.
4. Station stored in the memories may be over written by following the above procedure.
FM
<Scan setting >
Scan setting *
<All stations >
Scan setting
<Strong stations only >
Preset 2
Stored
1
3
GB
21