PERFECTPRO DAB+BOX2 Mode D'emploi page 8

Powering the radio
1. Battery operation
1. Installing the batteries, first turn battery cover fixture anti-clockwise to loosen and open the
battery cover.
Note:
Before you insert the batteries, if you use non-rechargeable batteries, make sure the
Charger/Batteries switch which located inside the battery compartment is switched to
Batteries position. If you use rechargeable batteries, make sure to switch Charger/Batteries
switch to Charger position.
2. Insert 4 X C size (UM-2) battery into the compartment. Ensure the batteries are inserted
in accordance with the diagram shown. Close the battery cover and fasten the fixture by
turning clockwise. If the radio is not to be used for any extended period of time, it is recom-
mended that the batteries are removed from the radio.
Reduced power, distortion and a "stuttering sound" or low battery red LED indication are all
signs that the batteries need replacing or recharging. (see below information on charging
the batteries)
When playing on (rechargeable) batteries the output power is less compared to the output
power when playing on AC mains power. Because of this the sound can be somewhat dis-
torted at the highest volume settings.
2. AC operation
Before you plug the AC power cord into the AC socket, make sure the voltage is correct. If you
have batteries in the radio and use the AC power cord, the batteries will automatically be dis-
connected.
Power cord storage is designed to store the cord when the radio is not in use.
GB
7