Scan Sensitivity Setting; Preset Stations; Storing Preset Stations - PERFECTPRO ROCKPRO Manuel De L'utilisateur

Calling up RDS information
When you are listening to a FM station with RDS system, repeatedly press the INFO
button to cycle through the information. This will only function if the reception level is
sufficient and clear.
a. Radio text (RT)
b. Program type (PTY) Displays the type of station being listened to, e.g. Pop,
c. Frequency
d. Date

Scan sensitivity setting

The radio will normally scan all stations from FM broadcasts including the weaker
signals. However, you may wish the Auto-scan to find only those stations with strong
enough signals to give good reception.
1. Press the ON/OFF button to turn on the radio.
2. Select the FM band by pressing the SOURCE button.
Press the MENU button, rotate the TUNING/SEEK/SELECT knob to "Scan
3.
setting".
4. Press the TUNING/SEEK/SELECT knob.
5. Rotate the TUNING/SEEK/SELECT knob to select between "All stations" or
"Strong station" (default is All stations).
The "Strong station" option will allow the radio to find strong signals only when
scanning.
6. Press the TUNING/SEEK/SELECT knob to confirm your setting. The display will
return to FM menu.

PRESET STATIONS

Storing preset stations

There are 80 memory presets in the radio, 40 for DAB and 40 for FM. Presets are
remembered by the radio in the event of a power failure.
1. Press the ON/OFF button to turn on the radio.
2. Press the SOURCE button to select the desired waveband.
3. Tune to the required station.
Press and hold the required PRESET button until the radio shows "Saved to
4.
preset".
5. Repeat step 3 and 4 for the remaining presets.
6. Stations stored in the preset memories can be over-written by following the above
procedure.
Displays the message about the station being listened to as
ticker text.
Classic, News, etc.
Displays the frequency of the station.
Displays the date of today.
GB
12