Setting The Clock Manually; Fm Auto Tune - PERFECTPRO MYBOX 2 Mode D'emploi

4. If you want to disable the clock time (CT) automatic adjustment function. Rotate the Tuning control to
select "CT OFF" and press the Tuning control to disable the function. Now the clock time can be set
manually, please follow the steps described in the section of "Setting the clock manually."

Setting the clock manually

. Clock can be set either the radio is power on or off.
2. Display will show "-:--" when the batteries are installed or when the radio is connected to the mains supply.
3. Press and hold the Menu button to enter the setting menu. Rotate the Tuning control until "TIME SET"
shows on the display. Press the Tuning control to enter the setting.
4. Rotate the Tuning control to set the desired hour. Then press the Tuning control to confirm the setting.
The minute digit will flash on the display.
5. Rotate the Tuning control to set the desired minute. Then press the Tuning control to confirm the setting.
Press the menu button to exit.
12/24 hour clock format
. Press and hold the Menu button to enter the setting menu. Rotate the Tuning control until 'CLOCK
24H (or 2H)' shows on the display. Press the Tuning control to enter the setting.
2. Rotate the Tuning control to choose between 2 or 24 hour clock format. Press the Tuning control to
confirm the setting.
Note:
The clock time will be shown also when the radio is off but only if the AC mains power remains
connected or batteries are installed. In case there is no power from either AC mains or batteries the
clock time will not be shown and not be continued, so it will have to be set again as described above.

FM AUTO TUNE

. Press the Power button to switch on your radio.
2. Rotate the Tuning control in a clockwise direction. The displayed frequency will increase. Then press
the Tuning control to carry out an auto-tune. Your radio will scan up the FM band from the currently
displayed frequency and will stop scanning when it finds a station of sufficient strength. To scan down
in frequency, rotate the Tuning control in an anticlockwise direction first and then press the Tuning control.
Your radio will scan down the FM band from the currently displayed frequency and will stop scanning
when it finds a signal of sufficient strength.
3. After a few seconds the display will update. The display will show the frequency of the signal found.
4. To find other stations press the Tuning control as before. When the end of the waveband is reached,
your radio will recommence tuning from the opposite end of the waveband.
5. Adjust the Volume to the required setting.
6. To switch off your radio, press the Power button.
Note:
If you find the reception level is poor, try repositioning the radio.
GB
6