Motorola MINITOR VI Guide D'utilisateur page 31

•
The pager monitors any activity on
both frequencies. If activity is
detected on either frequency, the
receiver will lock on to that frequency
until the transmission ends.
Note: Neither frequency will have
monitoring precedence over the other.
•
When the pager is locked on to either
of the scanned frequencies, the pager
will sound an alert to the correct
address tones for that frequency and
start message storage. The pager will
turn the audio off according to the
current Reset mode. The receiver will
then resume the scan activity.
•
Priority Scan:
•
This mode allows you to monitor
traffic on two different frequencies.
•
One frequency must be
preprogrammed as a priority
frequency; and the second frequency
can be preprogrammed as a
non-priority frequency.
Note: The priority frequency has
monitoring precedence over the
non-priority frequency.
•
If the receiver is in the Scan mode
and is monitoring frequency activity
on a non-priority frequency, the
receiver will scan back to the priority
frequency at programmed intervals. If
activity is detected on the priority
frequency the receiver will then lock
on to that frequency. Scanning is
stopped until the priority frequency
becomes inactive.
27
English