Motorola MINITOR VI Guide D'utilisateur page 32

•
At this time the receiver will resume
the priority scan activity. The pager
will only alert on the detection of alert
tones on the priority frequency. The
pager will then turn the audio off
according to the current Reset mode.
Address detection is turned off for the
non-priority frequency.
•
Silent Scan:
•
This mode allows you to monitor
traffic on two different frequencies.
Note: Neither frequency will have
monitoring precedence over the other.
•
The receiver alternately scans the two
frequencies and the audio remains
turned off. When a page is detected,
the pager generates a page alert and
performs message storage.
•
Upon receiving a page, the audio will
28
turn on immediately after the page
English
alert (enabling the carrier squelch
operation). The pager will then turn
the audio off according to the current
Reset mode. The receiver will then
resume the silent scan activity.
•
Disabled:
•
This mode allows you to disable a
Function Switch position. When
programmed, the pager will play a low
frequency tone when switching the
channel knob to this position.
Alert Type
This option allows you to set the type of
alerts to be activated when the pager is
powered up or when there is an incoming
page.
There are three different alert types
available.
•
Tone: The pager plays a tone.