mortiser with motor
workpiece stop with blank holder
2 table extensions
2 workpiece guides
gas spring
operating handle
catch socket
workpiece stop adjustment lever
Dimensions W/D/H mm.............................................................................................................580/430/780
Table size W/L mm .........................................................................................................................310 x 320
Table height mm ........................................................................................................................................ 45
Table adjustment W/D mm ............................................................................................................ 690 x 310
Drill stroke mm ........................................................................................................................................ 130
Distance drill – fence mm ......................................................................................................................... 85
Drill depth max. mm .................................................................................................................................. 76
Drill size max. mm ..................................................................................................................................... 12
Workpiece height max. mm .................................................................................................................... 135
Spindle speed 1/min.............................................................................................................................. 1380
Chisel capacity mm .............................................................................................................................. 6 - 12
Chisel shank/Bushing size mm ............................................................................................................ 19,05
Maximum chisel stroke mm .................................................................................................................... 135
D
Distance fence – centre chisel mm .......................................................................................................... 85
Chuck capacity mm.............................................................................................................................. 1 - 13
Weight kg .................................................................................................................................................. 38
Motor
Consumption power P1 W
Spindle speed
Plug
Subject to technical modifications!
• After unpacking, check all parts for any transport
damage. Inform the supplier immediately of any
faults.
• Later complaints cannot be considered.
• Make sure the delivery is complete.
• Before putting into operation, familiarize yourself
with the machine by carefully reading these
instructions.
• Use only original scheppach accessories, wea-
ring or replacement parts. You can find replace-
ment parts at your scheppach dealer.
Scope of Supply
tool holder
chisels with drill
feed key
small parts bag
operating manual
Technical data
230 V/ 50 Hz
370
1380
Schuko
General notes
• When ordering, include our item number and the
type and year of construction of the machine.
Note
In accordance with valid product liability laws, the
manufacturer of this device shall not be responsible
for damage to and from this device which results
from:
• Improper care.
• Noncompliance with the Operating Instructions.
12