GEZE TS 4000 R KM BG Instructions De Montage page 16

Mounting and securing
6.2.2 Mount door closer and lever
TS 4000 R (lever left)
Close adjustment valve (1.) (closing speed).
X
Move lever by 1 tooth (approx. 12°) towards screw-on
X
surface, position and screw down (3.).
Screw sliding lever (tightening torque: 14 Nm) (4.).
X
Pull open lever in the direction of the arrow (1).
X
For concealed connection, route 230 V mains cable into the terminal area (see section „Mains connection") (2.).
X
Screw down door closer (3.).
X
Slide the sliding rail from the strip side over the link-block guideif necessary, open lever again (4.).
X
GB 6
DIN left
TS 4000 RFS (FS-sliding lever right)
Close adjustment valve (1.) (closing speed).
X
Turn driver plate into the correct position (2.).
X
Move FS-sliding lever about 40° towards screw-on
X
surface, position and screw down (3.).
Screw sliding lever (tightening torque: 14 Nm) (4.).
X
TS 4000 R
DIN right
Fig.: 6.2.2.1
Fig.: 6.2.2.2