Video Analysis Page; Wash System Page; Movement Parameters Page - Videotec MAXIMUS MPXHD DELUX Manuel D'instructions

10.2.8 Video Analysis Page

The device can be configured to emit motion
detection alarms using ONVIF events.
This page allows you to define the following settings:
• Enable emission of motion detection events.
• Configure the algorithm sensitivity level.
Fig. 36

10.2.9 Wash System Page

Do not use the wiper if the outside
temperature is below 0°C or in case of ice.
From the menu, it is possible to configure the device
wash system functions.
Fig. 37
MNVCMPXHDB_1822_EN

10.2.10 Movement Parameters page

From menu entry Movement Parameters it is possible
to control, via web, all Pan & Tilt parameters.
• Options
• Offset Pan: The pan & tilt has a mechanically
defined 0° position. The Offset Pan function
allows the definition of a different 0° position
using software.
• Economy Mode: It reduces the motor's torque
when the Pan & Tilt is at standstill to decrease
consumption. Do not enable in the presence of
strong wind or vibrations.
• Autoflip: Turn the Pan & Tilt by 180° when the
tilt of the Pan & Tilt reaches the end run. It makes
it easier tracking subjects along corridors or
roads.
• Ceiling Mount: It rights the image and reverses
the handling controls.
• Manual Controls
• Maximum Speed: Sets the maximum manual
speed.
• Scan Speed: The speed, measured in degrees
to the second, at which a preset is reached by
explicit operator request.
• Tilt Factor: Sets the reduction factor of the tilt
axis manual speed.
• Speed with Zoom: When enabled, this
parameter automatically slows down the Pan &
Tilt speed, based on the Zoom factor.
31