Venting; Typical Vent Installation - Napoleon Havelock GDS50-1NSB Manuel D'installation Et D'opération

Masquer les pouces Voir aussi pour Havelock GDS50-1NSB:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

venting

EN
Do not allow the inside liner to bunch up on horizontal or vertical runs and elbows. Keep it pulled tight. A 1¼" (31.8mm) air gap
all around between the inner liner and outer liner is required for safe operation.
2.1

typical vent installation

34" (86.4cm)
29" (73.7cm)
minimum
30 3/4"
(78.1cm)
* See "venting" section
10
W415-2348 / B / 01.22.20
maximum
59 3/4"
(151.8cm)
minimum
plus rise*
16" (40.6cm)
minimum
40 ft
(12m)
maximum
36" (91.4cm)
minimum
30 3/4"
(78.1cm)

Publicité

Chapitres

Table des Matières
loading

Table des Matières