Makita UR101C Manuel D'instruction page 16

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Adjusting the hanger position
For UR101C only
For more comfortable handling of the tool, you can
change the hanger position.
1.
Loosen the screw on the hanger and slide it to a
comfortable working position.
1
2
► 1. Hanger 2. Screw 3. Cord
NOTICE:
When adjusting the hanger position,
also adjust the cord position.
2.
Adjust the hanger position as shown in the figure
and then tighten the screw.
750 mm
1
(29-1/2")
(29-1/2")
1
The hanger position from the ground
2
The cutting tool position from the ground
3
The horizontal distance between the hanger
and the unguarded part of the cutting tool
3
100-300 mm
(4"-11-3/4")
750 mm
2
3
Starting the operation
CAUTION:
Before operation, finish adjusting
the working position by following the instructions
in the section for the working position.
CAUTION:
Before operation, make sure that
the buckles on the waist belt is locked and the
tool is securely attached to the hook of the hang-
ing band.
CAUTION:
Always press the main power but-
ton to turn on the tool immediately before cutting
grass. Failure to do so may cause personal injury
due to unintentional start up.
1.
Install the battery cartridge(s) to the portable
power pack.
1
2
► 1. Portable power pack 2. Battery cartridge
NOTE: Refer to the instruction manual of your
portable power pack for how to install the battery
cartridges.
2.
Press the power button on the portable power
pack. The main power lamp will light up.
2
► 1. Main power lamp 2. Power button
16 ENGLISH
1

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ur201c

Table des Matières