Nylon Cutting Head - Makita UR101C Manuel D'instruction

Cutter blade
CAUTION:
When handling a cutter blade,
always wear gloves and put the blade cover on
the blade.
CAUTION:
The cutter blade must be well pol-
ished, and free of cracks or breakage. If the cutter
blade hits a stone during operation, stop the tool and
check the cutter blade immediately.
CAUTION:
Always use the cutter blade
with the diameter described in the section for
specifications.
5
6
► 1. Nut 2. Cup 3. Clamp washer 4. Cutter blade
5. Spindle 6. Receive washer 7. Hex wrench
1. Insert the hex wrench through the hole in the gear
case to lock the spindle. Rotate the spindle until the hex
wrench is fully inserted.
2.
Mount the cutter blade onto the receive washer
so that the arrows on the cutter blade and protector are
pointing in the same direction.
1
► 1. Arrow
3.
blade and then tighten the nut securely by the box
wrench.
1
2
► 1. Box wrench 2. Hex wrench 3. Loosen 4. Tighten
3
NOTE: Tightening torque : 20 - 30 N•m
4
4.
To remove the cutter blade, follow the installation proce-
dures in reverse.

Nylon cutting head

NOTICE:
cutting head.
7
1
► 1. Nylon cutting head 2. Spindle 3. Hex wrench
4. Loosen 5. Tighten
1.
case to lock the spindle. Rotate the spindle until the hex
wrench is fully inserted.
2.
tighten it securely by hand.
3.
To remove the nylon cutting head, follow the installation
procedures in reverse.
13 ENGLISH
Put the clamp washer and cup onto the cutter
1
3
Remove the hex wrench from the gear case.
Be sure to use genuine Makita nylon
4
5
2
Insert the hex wrench through the hole in the gear
Place the nylon cutting head onto the spindle and
Remove the hex wrench from the gear case.
4
2
1
3