Makita UR101C Manuel D'instruction page 14

OPERATION
Adjusting the working position
CAUTION:
Before performing this procedure,
install the battery cartridge(s) to the portable
power pack and finish the adjustments for the
waist belt and shoulder harness. Refer to the
instruction manual of the portable power pack for
detail.
CAUTION:
To prevent unintentional start up,
never turn on the portable power pack throughout
this procedure. The battery cartridge(s) is to be
installed only to obtain the usability with actual weight
balance.
1. Pull out the cord from the right side of the portable
power pack. When pulling out the cord, be sure to set
the cord in the holders as shown in the figure.
► 1. Cord 2. Holder
2.
Attach the hooks of the hanging band to the rings
of the shoulder belts or waist harness as shown in the
figure.
Attaching hanging band to the shoulder belt
3
2
1
► 1. Hanging band 2. Ring 3. Hook
1
2
3
2
14 ENGLISH
Attaching hanging band to the shoulder belt and
waist belt
3
2
1
► 1. Hanging band 2. Ring 3. Hook
3. Wear the shoulder harness of the portable power
pack and lock the buckle on the waist belt.
Adjust the length of the hanging band as necessary.
3
2