NSK Varios 370 Manuel D'utilisation page 7

Masquer les pouces Voir aussi pour Varios 370:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

3-4 Handpiece Holder
Peel off cover of the Double-Faced Tape.
Fix the Handpiece holder on the flat surface.
3-5 Handpiece Cord Holder and Control Unit
Holder
( Fig.4 )
Align the chase and Slide the Control Unit into
the Control Unit Holder.
Tuck the Handpiece Cord into Handpiece Cord
Holder.
Peel off the Double-Face Tape cover and put the
Control Unit Holder under the Table or Tray.
CAUTION
· Do not pull the Handpiece cord forcibly. This is
because water tube had bended forcibly that is
inside the Handpiece cord. Water may not be
out appropriately from the handpiece. ( Especially
for connection for Handpiece cord to Handpiece
cord Holder )
· You can mount Control Unit Holder on the Top
Surface and Bottom Surface.
3-6 Rubber Pad
To stop slipping the Control Unit on the table, mount the
Rubber Pad at the bottom of it.
1) Clean bottom of the Control Unit.
2) Fit the Rubber Pad appropriate place as shown on
the Fig.5.
CAUTION
Control Unit Holder is not mount to the bottom
when a Rubber Pad is attached to the bottom.
4. Mounting and Removing the Handpiece
Align the Dots on the Handpiece and the Handpiece Cord. Push
handpiece into connector.
To remove the handpiece, grip the Handpiece and plug of the
handpiece cord then pull it out stright. ( Fig. 6 )
WARNING
To avoid Electrical Shock Do not touch the handpiece
backend electrical contacts.
CAUTION
Always confirm that the handpiece is correctly seated and locked into place.
Varios370 EN-140501.indd
6
( Fig.3 )
Control Unit Holder
Chaser
Rubber
Pad
6
Double-Faced Tape
Double-Faced Tape
Handpiece
Cord Holder
Chaser
Dots
Handpiece backend
Handpiece
To flat surface
Fig.3
Handpiece
Cord
Fig.4
Fig.5
Handpiece Cord
Fig.6
2014/05/07
18:05:17

Publicité

Table des Matières
loading

Table des Matières