Table Des Matières - NSK Varios 370 Manuel D'utilisation

* Operation Principle
A sinusoidal electrical signal, at ultrasonic frequency ( f > 20kHz ) , is delivered by the generator. This signal is applied
to the 'piezoelectric ceramic' located inside the transducer. Piezoelectric ceramic converts this signal into mechanical
vibrations. These vibrations are at the same ultrasonic frequency as the electrical signal. The mechanical vibrations
are propagated towards the distal end of the transducer. The "TIP" insert, which is attached at the distal end of the
transducer, vibrates at ultrasonic frequencies and makes it possible to achieve the aimed purpose.
1. Component Names
3
Control Unit
1
( with Handpiece Cord Unshielded 2M )
Handpiece ( Varios2 or Varios2 Lux)
2
3 Control Unit Holder
1
AC Adaptor ( Unshielded cord 5M )
4
5 Handpiece Holder
6 Double-Face Tape
Foot Control ( Unshielded 5M )
7
8 Water Tube Set
Tip ( G4, G6, G8 )
9
Varios370 EN-140501.indd 3
10 Rubber Pad
1
11 Tip Wrench
2
1
Spanner Wrench ( 5x8 )
12
1
13 O Ring
1
Tip Cover S ( Option )
14
1
Tip Holder ( Option )
15
2
By an area, AC Adaptor Shape change
1
1
Either one is contained with the set that you purchased
2
1
Only 120 V
3
1
3
DC Plug
4
1
2
2
-
-
2014/05/07 18:05:16