Introduction; Legend For Explanatory Diagram Finecoat Split-Gun; Applications; What Kind Of Spraying Materials Can Be Applied - WAGNER FineCoat Split-Gun Mode D'emploi

Introduction

2. Introduction
These spray guns are designed for use in a High Volume/Low
Pressure (HVLP) painting system.
With an HVLP system, the highest quality professional finish can be
achieved with little preparation or setup time. HVLP systems are
not intended to replace airless systems. Instead, they are meant to
compliment airless by improving the final finish on the substrate,
minimizing waste, and reducing labor time.
The HVLP spray guns described in this manual include the turbine
cup gun and the turbine top feed gun. Please review all the
information contained in this manual before operating an HVLP
system.
i
The general operation and maintenance of each style
of HVLP spray gun are the same. For illustration
purposes, the turbine cup gun is pictured. However,
any information specific to a style of gun is described
where necessary. A parts listing for each style of gun
is included near the back of this manual.
i
Also familiarize yourself with the operating
instructions for the paint spraying unit.
2.1 Legend for explanatory diagram
FineCoat Split-Gun
1
2
3
4
5
6
7
GB
2.2

Applications

• Renovation and repair work
• Interior wall decoration
2.3

What kind of spraying materials can be applied?

• Water-soluble and solvent-containing coating materials
• Wood preservatives
• Multi-color effect materials
• Multi-color paint
• Texture and effect paints
2.4

Technical data

Container capacity
Weight
Max. pressure (working)
Max. permissible coating
temperature
Nozzle set
Max. Noise level
Max. pressure (gun without cup)
* Measured in 1 m distance from unit and 1.60 m above
reverberant floor, working with a FC 9900. Figure may vary if
another HVLP unit is used.
(*)
1. Air flow adjustment
knob
2. Material flow
adjustment knob
3. Trigger release
4. Packing nut
5. Trigger
6. Check valve
8
7. Air inlet
9
10
11
15
12
13
14
16
Gun and Cup Gun and Top
Feed Cup
1 l 600 ml
1.1 kg 0.80 kg
0.68 bar 0.41 bar
43º C 43º C
No. 4 (1.8 mm) No. 4 (1.8 mm)
76 dB (A)* 76 dB (A)*
Air: 1.4 bar Material: 3.4 bar
8. Lever
9. Air cap ring
10. Air cap
11. Fluid inlet
12. Cup locking lever
13. 1-liter cup assembly
14. Swivel tube lever
15. Top feed cup assembly
(*) The hook on top of the
gun body can be easily
removed or reversed.
Slide the hook toward the
rear of the gun to remove
it.
It is recommended that
the hook be removed
whenever using the top
feed cup assembly.
FineCoat Split-Gun