Power; Learn - Martin Logan Motion Vision Guide De L'utilisateur

at full brightness when a setting (such as volume or
input) is changed. After a few seconds, the display
will turn off. Activate by pressing the right direction-
al button and the soundbar will respond with 'SET'.
DISPLY > AUTO.DM: [AUTO DIM] This option
configures the soundbar's display to be on at a
reduced brightness when a setting (such as vol-
ume or input) is changed. After a few seconds the
display will turn off. Activate by pressing the right
directional button and the soundbar will respond
with 'SET'.
MENU OPTION: POWER
POWER: Enter the 'POWER' submenu by press-
ing the right directional button. Here you may
adjust how the soundbar turns on and off.
POWER > AUTO: This option configures the
soundbar to turn itself off after no audio signal is
detected for approximately 30 minutes. When the
soundbar detects an audio signal, it will immedi-
ately turn itself on. Activate by pressing the right
directional button and the soundbar will respond
with 'SET'. Please note: When set to 'AUTO',
if the soundbar is manually turned off (using the
power button on the top panel or remote control),
the soundbar will not respond to an incoming
audio signal and will not turn on automatically. In
this situation, turn the soundbar on using the power
button on the top panel or remote control and the
soundbar will resume automatic power handling.
POWER > FULL.ON: [FULL ON] This option
configures the soundbar to remain on at all times
until it is manually turned off using the power but-
ton on the top panel or remote control. Activate by
pressing the right directional button and the sound-
bar will respond with 'SET'.
MENU OPTION: LEARN
Please note: There may be remotes that the
soundbar cannot learn or that the soundbar can
not learn correctly. Due to the number of available
remotes it is impossible to advise which remotes
will or will not work.
Please note: When learning from a second remote, you
will likely find it does not have buttons that directly correspond
with all available soundbar commands. Not all commands
have to be programmed. Some remotes offer 'function'
buttons (F1, F2, etc.) that can be used to program unique
soundbar commands such as 'NITE.MD' or 'OPTIC.1'.
Please note: Some remote controls offer discrete
'power on' and 'power off' buttons. Some offer a single
button to toggle power on and off. The learning function
of the soundbar allows you to program either scenario.
LEARN: Enter the 'LEARN' submenu by pressing the
right directional button. The settings in this menu pro-
gram the soundbar to respond to a second remote
control. The factory supplied remote control will
always work with the soundbar, even if the soundbar
is programmed to respond to a second remote.
Using the up/down directional buttons, you can
select and program the following commands:
• VOL+ [VOLUME +]
• VOL– [VOLUME –]
• MUTE [MUTE VOLUME]
• NX.INPT [NEXT INPUT]
• PR.INPT [PREVIOUS INPUT]
• NITE.MD [NIGHT MODE]
• NRML.MD [NORMAL MODE]
• BASS.MD [BASS+ MODE]
• PWR.TGL [POWER TOGGLE] (toggle on/off)
• PWR.ON [POWER ON] (power on only)
• PWR.OFF [POWER OFF] (power off only)
• MENU
• OPTIC.1 [OPTICAL 1 INPUT] (direct access)
21