Martin Logan Motion Vision Guide De L'utilisateur page 8

If no stud is found: use the center most screw
location and drill a pilot hole for the wall anchor.
Install a wall anchor at this location. If a wall
stud is found: drill a pilot hole into the stud.
4 Using a screw, attach the wall bracket to the
wall. DO NOT tighten (fig 2b).
5 Using a stud finder, determine if a wall stud
is directly behind any of the remaining screw
locations (fig 2a).
If no stud is found: use the top and bottom
center-most screw locations. If a wall stud is
found: use the top and bottom screw locations
with a stud behind them.
Use a level to square the wall bracket and
mark the remaining pilot hole locations (fig 2b).
6 Remove the wall bracket or pivot to access the
remaining screw locations (fig 2b).
If no stud is found: drill pilot holes and install
wall anchors. If a wall stud is found: drill pilot
holes into the stud.
7 Using the screws, attach the wall bracket to the
wall. DO NOT fully tighten.
8 Use a level to square the wall bracket. Tighten
all screws (fig 2b).
9 Attach audio and power cables as needed.
Refer to the 'Connection' section of this manual.
10 Move the soundbar into place and drop the
shoulder bolts into the wall bracket keyholes.
Before releasing, make sure the soundbar has
dropped fully into the keyholes and is held firm-
ly in place (fig. 3).
8
Fig. 2a
Fig. 2b