Martin Logan Motion Vision Guide De L'utilisateur page 3

such as vases, are placed on the apparatus.
21. Batteries (battery pack or batteries installed)
shall not be exposed to excessive heat such
as sunshine, fire, or the like.
22. For apparatus mounted to wall, the appara-
tus shall be installed on solid wood, bricks,
concrete or solid wood columns and battens.
WARNING: This product is intended to be operated
ONLY from the AC Voltages listed on the back panel
or included power supply of the product. Operation
from other voltages other than those indicated may
cause irreversible damage to the product and void the
products warranty. The use of AC Plug Adapters is cau-
tioned because it can allow the product to be plugged
into voltages in which the product was not designed to
operate. If the product is equipped with a detachable
power cord, use only the type provided with your prod-
uct or by your local distributor and/or retailer. If you
are unsure of the correct operational voltage, please
contact your local distributor and/or retailer.
This device complies with part 15 of the FCC
Rules and RSS-210 of Canada licence-exempt
RSS Standard(s). Operation is subject to the follow-
ing two conditions: (1) this device may not cause
interference, and (2) this device must accept any
interference, including interference that may cause
undesired operation of the device.
Note: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. The limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harm-
ful interference to radio communications. However,
there is no guarantee that interference will not occur
in a particular installation. if this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try
to correct the interference by one or more of the fol-
lowing measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a cir-
cuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV
technician for help.
Approved under the verification provision of FCC
Part 15 as a Class B Digital Device.
Caution: Changes or modifications not expressly
approved by the manufacturer could void the
user's authority to operate this device.
This Class B digital aparatus complies with
Canadian ICES-003. Cet appareil numérique de
la classe B est conforme à la norme NMB-003 du
Canada.
WIRELESS TRANSMITTER COMPLIANCE INFORMATION
The term "IC:" before the radio certification num-
ber only signifies that Industry Canada technical
specifications were met.
This equipment complies with FCC and IC radia-
tion exposure limits set forth for an uncontrolled
environment. This equipment should be installed
and operated with minimum distance 20cm
between the radiator and your body. This trans-
mitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
To reduce potential radio interference to other
users, the antenna type and its gain should be so
chosen that the equivalent isotropically radiated
power (e.i.r.p.) is not more than that permitted for
successful communication.
3