Martin Logan Motion Vision Guide De L'utilisateur page 14

subwoofer connection, connect "Sub Out" from the
soundbar to the "LFE In/Sub In" on the subwoofer.
Use the soundbar's menu system and choose 'SUB
> WIRED'.
Reference your subwoofer's manual to learn
how to properly adjust the sub's level and phase
controls to achieve proper blending with the sound-
bar. The subwoofer's crossover should be set to
"bypass", "LFE". For subwoofers that do not have a
"bypass" or "LFE" crossover setting we recommend
adjusting the crossover to its highest setting.
Wireless Subwoofer Connection
Press the subwoofer's sync button and hold for 3
seconds. The subwoofer's LED will blink quickly.
Use the soundbar's menu system and choose 'SUB
> WIRELS > SYNC'. The soundbar will display
'PSH.BTN' [PUSH BUTTON].
If pairing has completed successfully, the subwoofer's
LED will stop blinking and remain on and the sound-
bar will display 'SYNCED'. Please note: If a link
is not established after 30 seconds, the subwoofer's
LED will start blinking slowly and the soundbar will
display 'FAILED'. Repeat if syncing fails.
Please note: MartinLogan once utilized a
wireless subwoofer connection system named
"SWT-1". Subwoofers equipped with SWT-1 tech-
nology are not capable of wireless connectivity
with this soundbar—a wired connection will work
for these subwoofers.
WARNING! When operating wirelessly, the sub-
woofer may be susceptible to RF interference in the
2.4GHz bandwidth from microwave ovens and
wireless devices such as WiFi systems, video game
consoles, cordless telephones, bluetooth devices,
and baby monitors. Generally, this issue (intermittent
sound or slight popping noises) is easily resolved by
14
physically separating problematic devices from one
another—a distance as little as two feet will often
alleviate the interference. In the case of microwave
ovens, the interference will only occur when the
microwave is operating.
Reference your subwoofer's manual to learn how
to properly adjust the sub's level and phase con-
trols. The subwoofer's crossover should be set to
"bypass" or "LFE". For subwoofers that do not have
a "bypass" or "LFE" crossover setting we recom-
mend adjusting the crossover to its highest setting.
Please note: If you decide to no longer use
wireless, turn off the soundbar's wireless transmitter
by using the menu system and choosing 'SUB >
WIRELS > TRN.OFF' [TURN OFF] or 'SUB > NO
SUB'. Doing this will turn off the transmitter and
automatically set the soundbar for no sub.
Using a MartinLogan Dynamo Subwoofer
If using a MartinLogan Dynamo family sub-
woofer, we recommend beginning with the
following subwoofer settings:
Low-pass: Bypass
Phase (wired connection): 0
Phase (wireless connection): 180
Volume: Knob set to vertical (12-o'clock to
1-o'clock position)