Publicité
Les langues disponibles
Les langues disponibles
Wireless-G Broadband Router with SpeedBooster
The Administration Tab - Factory Defaults
Click the Yes button to reset all configuration settings to their default values, and then click the Save Settings button. Any
settings you have saved will be lost when the default settings are restored. This feature is disabled by default.
Figure 3-44: Administration Tab - Factory Defaults
The Administration Tab - Firmware Upgrade
Firmware can be upgraded by clicking the Upgrade button after browsing for the firmware, which you can download from the
Linksys website. Do not upgrade your firmware unless you are experiencing problems with the Router. For more information
about upgrading firmware, refer to "Appendix C: Upgrading Firmware".
Figure 3-45: Administration Tab - Firmware Upgrade
The Administration Tab - Config Management
This screen is used to back up or restore the Router's configuration file.
To back up the Router's configuration file, click the Backup button. Then follow the on-screen instructions.
To restore the Router's configuration file, click the Browse button to locate the file, and follow the on-screen instructions.
After you have selected the file, click the Restore button.
Change these settings as described here and click the Save Settings button to apply your changes or Cancel Changes to
cancel your changes
Figure 3-46: Administration Tab - Config Management
Chapter 3: Configuring the Wireless-G Broadband Router
30
The Administration Tab - Factory Defaults
Publicité
