Initial Use; Examining The Lamp And The Scope Of Delivery; Removing / Replacing The Backup Battery; Connecting The Lamp To The Power Supply - LIVARNO LUX 55011 Instructions D'utilisation Et Consignes De Sécurité

Initial use

Examining the lamp and
the scope of delivery
NOTE: RISK OF DAMAGE!
Opening the packaging carelessly with a sharp
knife or other sharp objects may damage the lamp.
Open the packaging with care.
1. Remove the lamp, connection cable
the mains adapter
remove all protective film.
2. Verify the scope of delivery is complete (see Fig. A).
3. Check the lamp and accessories for damage.
Do not use the lamp if you detect any type of
damage. In this case, please contact the manu-
facturer (see "Service Address").
Backup Battery
The backup battery is already installed.
Remove the insulating strip from the underside
of the lamp before first use.
When disconnecting the lamp from the mains, any
settings, e.g. time and alarm, will be lost. The backup
battery ensures the settings will not be lost and with
the alarm function enabled the alarm will sound at
the set time even with the display
and not being able to use the LED lamp. Once re-
connected to the mains, the display
again and the LED lamp
Removing / replacing the
backup battery (see Fig. C)
1. Open the battery compartment on the bottom
of the lamp by loosening the screws in the
cover using a Phillips screwdriver.
8
2. Remove the used battery.
3. If applicable, insert a new battery of the same
type (see "Technical data").
4. Reinstall the cover
5. Close the battery compartment by slightly press-
ing the cover into the battery compartment
8
and tightening the Phillips screw again.
and
10
from the packaging and
12
being unlit
3
will light up
3
can be used again.
1
over the new battery.
8
Connecting the lamp to the
power supply
1. Insert the jack of the connection cable
the connection socket
2. Insert the USB plug of the connection cable into
the port of the mains adapter.
11
3. Plug the mains adapter
stalled socket to connect the lamp to the mains.

Setting the time and date

NOTE: If no buttons are pressed for more than 60
seconds whilst setting the time or date, the process
will be cancelled and any settings lost.
NOTE: When adjusting the settings in time mode,
the symbol will continuously flash in the function
display.
1. If applicable, press the Mode button
switch from alarm mode to time mode. A beep
will sound and the
the function display
2. Press the Select button
A beep will sound and the top line in the time
display will flash.
15
3. Use the /
4. Press the Select button
A beep will sound and the bottom line in the
time display will flash.
1
5. Use the /
6. Press the Select button
A beep will sound and both lines in the display
will flash.
7. Use the /
The weekday in the date display
automatically.
8. Press the Select button
A beep will sound and the first field in the date
display will flash.
9. Use the /
10. Press the Select button
A beep will sound and the second field in the
date display will flash.
11. Use the /
12. Press the Select button
The date and time have been set.
Initial use
of the lamp.
5
into a properly in-
12
symbol will appear in
.
14
:
7
button to set the current hour.
9
to confirm the setting.
7
button to set the current minute.
9
to confirm the setting.
7
button to set the current year.
9
will correct
16
to confirm the setting.
7
button to set the current month.
9
to confirm the entry.
7
button to set the current date.
9
to confirm the entry.
7
into
10
to
6
GB/IE 19