Checklist When Data Is Missing On The Display - ADE WS 1911 Mode D'emploi

From now on, the weather station automatically switches
to receiving-mode multiple times each night. During this
process, the displayed time is compared with that received
from the time signal transmitter and, if necessary, corrected.
If no sufficiently strong signal has been received,
the base station aborts the receiving process after a
few minutes and the radio-tower symbol goes out. The
receiving process is started again at a later point in time.
In this case, the time proceeds as usual (beginning with
the start time of "00:00").

Checklist when data is missing on the display

No data display from the time signal transmitter
1. Check whether the location of the base station is
suitable, see "Choosing a location".
2. Start the reception process again manually by
pressing and holding down the
approx. 3 seconds.
3. Wait until the base station automatically switches
back to reception at a later time. The reception is
usually better at night.
4. Manually perform the settings if reception is not
possible at your location, see "Setting the time and
date manually".
WS 1911 weather station
button for
63