ADE WS 1911 Mode D'emploi page 69

Procedure:
1. Place the base station and new outdoor sensors close
together.
2. Remove the battery compartment cover on the rear
side of the outdoor sensor.
3. Use the switches to set a separate channel for each
new outdoor sensor. Since the sensor included in the
scope of delivery uses channel 1 as standard, select
channel 2 for the second sensor and channel 3 for the
third one.
4. Insert two batteries of the type indicated on the base.
Pay attention to the correct polarity (+/-).
5. Replace the battery compartment cover.
Using the button, select the corresponding outdoor
sensor (1, 2 or 3) in order to have its data displayed. Pay
attention to the following:
‚ You can also press the
base station display shows
sensor number. This is a sign that the data from the
outdoor sensors will automatically be called up and
displayed in succession.
‚ If the channel number is not displayed after inserting
the batteries, press the TX button for the respective
wireless sensor. This way, the weather data is
transmitted directly to the base station.
You can then set up the new outdoor sensor at its own
installation site.
WS 1911 weather station
button repeatedly until the
next to the outdoor
69