Specification; Dimensions And Connections; Wiring Diagram - Stiebel Eltron SNU HOT Instructions De Montage Et D'utilisation

CLEANING, CARE AND MAINTENANCE
Speci cation
Pull off the temperature selector.
Remove the screws underneath the temperature selector.
Lower the locking screws inwards, pivot the cap upwards and
remove it.
Replacing the power cable
The power cable may be replaced with the original spare
part by a qualified contractor. Alternatively, the "H05VV-
F3x1.0" power cable may be used.
Insert the power cable into the retainer.
Checking the earth conductor in accordance with BGV A3
Unplug the power cable plug.
Pull off the temperature selector.
Carry out measurements at the mounting screw of the tem-
perature controller and at the earth conductor contact of the
power cable.
18 |SNU HOT (BLANCO HOT hot water system)
14. Specification

14.1 Dimensions and connections

SNU HOT
263
140
c08 c01
100
c01 Cold water inlet
c08 Boiling water outlet

14.2 Wiring diagram

1/N/PE ~ 220 - 240 V
5
4
3
L N
1 Temperature limiter (safety fuses)
2 Temperature sensor
3 PCB
4 ON indicator (LED)
5 Electrical heating
230
70
Male thread G 3/8 A
Male thread G 3/8 A
1
2
www.stiebel-eltron.com