Sharp AJ-5030 Mode D'emploi page 117

Dialing and transmission problems
Problem
No dial tone when you
press the SPEAKER key.
Dialing is not possible.
The power is on, but no
transmission takes place.
Nothing is printed at the
receiving end.
A distorted image is
received at the other end.
• Make sure the line cord is connected to the TEL.
LINE jack and a wall jack.
• Make sure the power cord is properly plugged into
a power outlet.
• Make sure that the telephone line is properly
connected to both the TEL. LINE jack and the wall
jack.
• Make sure that the fax machine is set to the correct
dialing mode for your telephone line. See
Connecting the telephone line cord on page 17.
• Make sure that the receiving machine has paper.
• Make sure that the telephone line cord is plugged
into the TEL. LINE jack, and not the TEL. SET jack.
• If the receiving machine is in manual mode with no
attendant, reception will not be possible.
• Check the display for error messages.
• Press the SPEAKER key and check for a dial tone.
• Make sure that the document for transmission is
placed face up in the auto document feeder, or
face down on the document glass.
• Noise on the telephone line may cause distortion.
Try sending the document again.
• Make a copy of the document on your machine. If
the copy is also distorted, your machine may need
service.
Faxing Problems
Solution
115