Sharp AJ-5030 Mode D'emploi page 79

Error Correction Mode
The fax machine is set to automatically correct any distortions in a
transmission due to noise on the telephone line before printing at the
receiving end. This function is called Error Correction Mode (ECM).
ECM is effective for both transmissions and receptions, and is only
effective when the other fax machine has ECM as well.
If desired, you can turn ECM off. This will slightly increase the
amount of memory available for memory transmission and reception.
1
Press these keys:
The display will show:
ECM MODE
1=YES, 2=NO
2
Press 1 to turn on ECM or 2 to turn it
off.
3
Press the STOP key repeatedly to
return to the date and time display.
Retransmission times (for memory transmission)
If a line error or power failure occurs during transmission from
memory, your fax will automatically redial the number and attempt to
complete the transmission. Retransmission will begin from the page
that was being transmitted when the error occurred.
Your fax has been set at the factory to make 2 attempts at memory
retransmission. If you wish to change the number of attempts, follow
these steps:
Optional Settings for Sending Faxes
FUNCTION
4 0
YES NO
or
1 2
STOP
7
77