MINN KOTA COPILOT Manuel Du Propriétaire page 9

6
ITEM(S) NEEDED
#3 x 3
k. Take the new CoPilot Cover (Item #1) and place it
over the CoPilot Reveiver that was just installed.
Attach the CoPilot Cover to the Right Sideplate
with the three 8-18 X 1/2 Screws (Item #3) using
a #2 Phillips Screwdriver.
NOTE: The old CoPilot Cover that was removed
at the beginning of the installation will no longer
fit on the Right Sideplate. This helps to make
sure that the new CoPilot Cover is installed in
case of an accidental mix-up.
7
l. Remove the Dust Cap from the Connection Port
located towards the back end of the exposed side
of the motor on the right side of the Mount.
m. Take the Power Connection that comes off of the
CoPilot Receiver, which is attached to the Right
Sideplate and plug it into the Connection Port.
NOTE:
Do not apply lubricant or any type of
grease to trolling motor connectors. Make sure
that the flat sides of the Power Connection and
Connection Port align so the plugs connect
together correctly.
8
n. Be sure that the Power Connection sits
comfortably between the Mount and the Right
Sideplate and cannot be pinched.
o. Reseat the Right Sideplate.
©2016 Johnson Outdoors Marine Electronics, Inc.
#1 x 1
Screws
7l
Connection Port
Dust Cap
Mount
INSTALLATION
CoPilot Receiver
Antenna
Connection
CoPilot Cover
7m
Connection Port
Power Connection
Power Connection
Right Sideplate
minnkotamotors.com | 9
Power